Repairing the Valuable Antique Collections

Jul 9, 2014

Vintage guns are useful  collections untill they are In good condition. Others that require a bit of work can usually be cleaned and restored by amateurs. Cast steel pieces or hardwood blanks which might be formed to switch broken or lacking shares, may be obtained from specialist suppliers. Even old gunpowder explodes, so ensure that any gun being repaired is just not loaded. Insert the ramrod, or a size of wood, into the barrel to examine if there is any obstruction. One can remove it with a contemporary shotgun cleaning rod that has a screw tip, or use an ordinary metal screw soldered to a stiff piece of wire.

Cleaning the Mechanism

To open up a flintlock mechanism, loosen the 4 screws that hold the mainspring, sear, sear spring and the bridle. Compress the mainspring in a small hand vice, take out the spring screw and remove the spring. The pin at the rear of the mainspring engages within the lock-plate and the opposite finish of the spring engages in the toe of the tumbler.

Clear the rust with positive emery powder or paper. Make sure to take away all abrasive powder after cleaning. Smear all parts with petroleum jelly and reassemble. Press the tumbler down to the fired position in order that the top of the mainspring goes over it. Put the cock on and pull it back to the half-cocked place so that the tumbler toe compresses the mainspring. Refit the remainder of the items in reverse order to removal.

Remove the tang screw and the retaining bands. The trigger guard, butt cap and ramrod pipes are screwed or pinned and must be removed with excessive care. If the screws do not yield to penetrating oil, leave them alone, it may be a job for an antique restorer to drill them out. Barrels and different metal elements can be cleaned with a mixture of oil and paraffin. Re-polish all elements with progressively finer abrasives; finish with jewelers' emery or crocus paper. Some barrels may have been blued to forestall rust and, particular bluing fluid could be bought from a gunsmith. Strive not leaving finger prints on the barrel as this causes rusting.

The latest stock may be fashioned with an entirely new piece of wooden if the stock is past minor repairs, . Small dents in the stock may be extracted by using hot steam from an iron. Place a cloth over the dent and apply the new iron.

Importance Antique Flasks

The vast majority of antique flasks had been made pear-shaped and produced from tin, brass or English metal. Metal flasks have been usually made in two halves soldered together. If the seam has parted, find out what alloy the flask is fabricated from before trying to re-solder it. A simple check is to place a couple of drops of water in a cup and add an equal number of drops of nitric acid, obtainable from a chemist. Put a drop of the solution on the metallic to reveal the color. Read more here

To shine the vintage flask, use the technique acceptable to the material it's made of. Many powder flasks have very tremendous detailed etchings, embossing or engravings that give them their unique look. A vintage collection without its matching or specific powder flask quickly loses its appeal.


Leave a Comment:


Homepage (optional)